EM-J5-M3601 - Arc cutter

Emrys Industries A TC Company

The EM-J5-M3601 - Arc cutter was developed for use in the EM-J5 Flying Assistant Robot Series (FARS), it became available in YE 36.

About the EM-J5-M3601

This accessory attaches to one of the connectors on the EM-J5. It is has a swivel joint that allows the accessory to bring the cutter parallel to the ground. The shaft of the J5-M3601 telescopes to allow the cutter to be used without risk to the robot. Attached to the base of the shaft is an air pump that allows the cutter to operate.

It is capable of operating for up to 60 seconds. It is designed to clear away debris or obstacles; it can easily slice through a chain-link fence or a sheet of corrugated steel.

Details